Pelco EW5001 Network Card User Manual


 
6 C2681M (2/08)
Before You Begin
Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video. Therefore, always include your network
administrator when planning and installing Endura components.
You will also need the following items:
Pelco-approved Endura certification
Access to an Endura network
that is an active, Gigabit Ethernet network that supports the full Internet Protocol suite,
that is configured with at least one Endura system manager,
that is configured with at least one Endura workstation, and
that will be configured with at least one EW5301T wireless video encoder or one EW5001 or EW5002 wireless bridge.
Wireless site plan, designed by a Pelco-certified wireless design consultant
NOTES:
Endura components are designed to deliver high-quality, high-frame rate video across a network. For best results, make sure your
installation meets the power, environmental, and networking guidelines described in the Endura Installation Guidelines and Best Practices
document (C2670M).
When using one or more network switches on the Endura network, enable autonegotiation on all switches.
These network requirements represent the minimum standard for a small Endura-capable security network. Please consult the Endura
Network Design Guide (C1640M) to make sure your network is properly configured. Your system may be different and may require
additional hardware, software, and network resources.
PARTS LIST
NOTE: Antennas are not included with the EW5001.
USER-SUPPLIED PARTS
In addition to the standard tools and cables required for a video security installation, you will need to provide the following items:
You will also need any tools required for installing the specific mount (refer to the mount documentation).
Qty Description
1 EW5001 wireless access point:
1 EW5001 unit
1 Junction box (J-box)
1 Power connector and cable
1 Weatherproof network connector
1 EW5001 Installation manual (C2681M)
1 EW5001 Configuration manual (C2684M)
1 Wireless Antenna Installation manual (C2698M)
1 Safety instructions
Qty Description
1 Power source; refer to Power and Network Wiring on page 13 for more information
1 Cat5e (or better) unshielded twisted pair (UTP) cable and connectors for connecting the EW5001 to the Endura network:
Weatherproof
Silicon filled
Long enough to reach the EW5001 from the network switch, up to 328 ft (100 m)
1 or 2 7/16-inch wrench
1 Digital voltmeter (DVM) with BNC adapter
1 Antenna
1 Antenna cable