Open as PDF
of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362
5A,A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
3-pin plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5A. If a plug without a fuse is
used, the fuse at the distribution board should
not be greater than 5A.
Note: The severed plug must be destroyed to
avoid a possible shock hazard should it be
inserted into a 13A socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - "NEUTRAL" ("N")
BROWN - "LIVE" ("L")
GREEN & YELLOW - "EARTH" ("E")
1. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is
marked with the letter "E" or by the Earth symbol
or coloured GREEN or GREEN AND
2. The BLUE wire must be connected to the
terminal which is marked with the letter "N" or
3. The BROWN wire must be connected to the
terminal which marked with the letter "L" or
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath of
file:///D|/rita/LF2/LF2/LFa1/multi_manual/english/107X/safety/regs/regulat.htm (10 of 11) [10/3/2001 4:12:02 PM]