Filter
Top Products
7-17
7.2.7. Setting the Palm Top Cover Sheet, Palm Top Cover, Touch Pad Adhesion Seat, Touch
Pad SW Knob, LED PCB And SW LED PCB
1. Set the SW LED PCB.
2. Attach the Power LED Packing Sheet to the LED Spacer
Sheet.
3. Attach the LEDX6 Spacer Sheet on the SW LED PCB.
4. Fix the SW LED PCB using the Screw. <K2-42>
5. Attach the PW LED Sheet.
6. Pass the Cable of LED PCB through the hole 1 on the Top
Cabinet, then set the LED PCB.
7. Attach the LES Spacer Sheet on the LED PCB.
8. Set the touch Pad SW Knob In and Touch Pad SW Knob
9. Attach the TP Bottom Tape to the Touch Pad.
10. Pass the Cables of the Touch Pad through the hole 2 on the
Top Cabinet, set the touch Pad.
11. Attach the Touch Pad Adhesion Seat.
12. Fix the Palm Top Cover using the 5 Screws. <N29> No1 to
No5
13. Attach the Palm Top Cover Sheet.
Note:
Tighten the Screws in the numbered order (No1 to No5).
Screws <K2-42>: DRQT26+D4NLT
Screws <N29>: DRQT26+E3FNL
■ Preparation of SW LED FPC
PalmTopCoverSheet
<N29>
<K2-42>
PalmTopCover
PWLEDSheet
TouchPadAdhesionSeat
TouchPad
LEDPCB
TouchPadSWKnob
TouchPad
SWKnobIn
PWLED
PCB
SWLED
PCB
<N29>
<N29>
<N29>
<N29>
No.4
No.2
No.5
No.3
No.1
Hole1
Hole2
0.50.5
11
AttachtheTape
AttachtheSheet
*Notes:
1.Applytheloadwhenattachingtheparts.20Nto30N(2to3Kgf)/cm2
Useapinset.
WhiteFullLine:MountainFold
AttachitnottooverlaptheSWleg.
FlexNotchStandard01
WhiteDottedLine:ValleyFold
SW-LEDFPCAss'y