Filter
Top Products
23
22
RECEIVER CONTROL
R
CVR SET ID allows you assign a specific number to
a Net1Card Receiver TV. Each Receiver TV in the
Net1Card network should have a Set ID. This allows the
Transmitter TV to send a specific message this TV. It also
allows the Transmitter TV to check to make sure the TV
is hooked to the network (more later). You can select a
number between 0 and 32,767.
If not already in the “RECEIVER CONTROL”
menu, press the D button on the remote control. Then
press the ▼ button to highlight “RCVR SET ID.”
Press the Number buttons 0 - 9 (or the + or - but-
ton) to select a Receiver ID for the TV. To set a TV with
a single-digit number, press one number. For example,
for 9 press the Number button 9. For a two-digit number,
press two numbers. For 14, press the Number button 1,
then the 4 button.
When finished, press the ▼ button to highlight
“EXIT.” Then press the “M” button. Or you can exit by
simply pressing the RECALL button when you’re done.
BEGIN
TRANSMITTER CONTROL
O
nce you have completed your general selections
under the Commercial Settings menu, you must
make specific selections. If you selected “TRANSMIT”
(See page 19.), follow the directions below.
If not already in the “TRANSMITTER CON-
TROL” menu, press the D button on the remote control.
“ADDRESS TYPE” should be highlighted. Address
Type allows you to select which TV(s) your message
will be sent to. That way, you can send a message only
to one TV (“SET”), a group or groups of TVs
(“GROUP”), or all the TVs (“BROADCAST”) in the
Net1Card network.
Press the – (
ᮤ) or + (ᮣ) button to select “BROAD-
CAST,” “GROUP,”or “SET.”
Next, press the ▼ button to highlight “GROUP
IDS.” If you selected “BROADCAST” from “ADDRESS
TYPE,” “ALL SETS” appears beside “BROADCAST”
on the next line and you go on to “RCVR POWER.”
If you selected “GROUP,” use the remote control’s
Number buttons 1 - 8 to select one or more groups to
send your message to. To remove a group selection,
press that Number button again. (Note: more than one
group can be selected.)
If you selected “SET,” use the Number buttons 0 - 9 to
select the individual TV to send your message to. For
136, press 1, 3, then 6.
When finished, press the ▼ button to highlight
“RCVR POWER.”
BEGIN
RECEIVER CONTROL
RCVR GROUP IDS – – – – – –
RCVR SET ID 0
EXIT MENU
+/– OR DIGITS TO CHANGE
TRANSMITTER CONTROL
ADDRESS TYPE BROADCAST
BROADCAST ALL SETS
RCVR POWER CURRENT
RCVR VOLUME CURRENT
RCVR CHANNEL CURRENT
RCVR LOCKOUT UNLOCKED
UPDATE RCVR TVS
EXIT MENU
PRESS +/– TO CHANGE
TRANSMITTER CONTROL
ADDRESS TYPE GROUP
GROUP IDS – – – – – – – –
RCVR POWER CURRENT
RCVR VOLUME CURRENT
RCVR CHANNEL CURRENT
RCVR LOCKOUT UNLOCKED
UPDATE RCVR TVS
TRANSMITTER CONTROL
ADDRESS TYPE SET
SET ID 0
RCVR POWER CURRENT
RCVR VOLUME CURRENT
Net 1Card IB 2/15/00 12:18 PM Page 22