Filter
Top Products
31
BEGIN
TELEVISION OPERATION
Press the POWER button to turn the TV ON.
Press the VOLUME UP (▲) or DOWN (▼)
button to adjust the sound level.
Press the CHANNEL UP (▲) or DOWN (▼)
button to select TV channels.
The TELEVISION CONTROL PANEL
MENU ▼ Button - Brings the on-screen menu up and allows
the user to scroll thru the options.
SLEEP Button - With the Net1Card assembly installed, the
Sleep option at the television control panel is rendered inopera-
ble.
MENU ▲ Button - Will clear the screen when the on-screen
menu is visible.
CC Button - Will bring up the Closed Captioning options.
Repeated pressing of this button will allow the user to change
those options.
CHANNEL ▼▲ Buttons - Use these buttons to scroll thru
available channels. These buttons will also allow you to scroll
thru the on-screen menu options when displayed.
VOLUME ▼▲ (- or +) Buttons - Use these buttons to
increase or decrease the audio level output of the TV. The (-) or
(+) function for these buttons is to select certain options from
within the on-screen menu.
POWER Button - Toggle between turning the TV ON and OFF.
6
+
MENU
CH
VOL
POWER
–
▼ ▲
▼
▲
▼
▲
SLEEP
CC
1
3
2
Note: The KEYBOARD Buttons can be controlled using the
“FRONT KEYPAD” feature within the “Commercial Settings”
menu (refer to page 18 for more details).
30
FACTORY TEST MENU
O
nce you have completed your general selections
under the Commercial Settings menu, you must
make specific selections. If you selected “FACTORY”
(See page 19.), follow the directions below.
If not already in the “FACTORY TEST MENU,”
press the D button on the remote control. “RCVR SET
ID” should be highlighted.
Press the – (
ᮤ) or + (ᮣ) button to select the number
of the Receiver TV you want to poll. You can also use
the Number buttons to select a number. For example,
select number 40.
Next, press the ▼ button to highlight “POLL
RECEIVER TV.” Then, press the + (
ᮣ) button to poll
the TV you selected. If the set is connected to the
Net1Card network (and even if it’s turned off) you will
receive a message saying “RESPONSE FROM SET 40.”
If the set with the number 40 is not connected, the mes-
sage will read “NO RESPONSE FROM RCVR.”
If you receive a “RCVR RESPONSE INVALID” mes-
sage, see page 39.
When finished, press the ▼ button to highlight
“EXIT.” Then press the “M” button. Or you can exit by
simply pressing the RECALL button when you’re done.
BEGIN
FACTORY TEST MENU
RCVR SET ID 40
POLL RECEIVER TV
EXIT MENU
+/– OR DIGITS TO CHANGE
FACTORY TEST MENU
RCVR SET ID 40
POLL RECEIVER TV
EXIT MENU
PRESS + TO POLL
Net 1Card IB 2/15/00 12:18 PM Page 30