Filter
Top Products
4 - 8 Users Manual
4.4 GETTING STARTED
The various parts of this tutorial must be executed sequentially. Before startin
g
with this tutorial, make sure the power supply is in the local state. If the supply is
in the remote state (REM is displayed), press . If the REM text does not
disappear, the LCL key is disabled remotely by the Local Lockout (LLO) command
from the GPIB controller.
If the display shows the measured output volta
g
e and current of one of the output
channels, the power supply is in the OPERATE mode. Before startin
g
with the
tutorial, set the power supply to the STANDBY mode by pressin
g
the key.
Notes: • For multiple output models the selected output channel number n will
be displayed.
• For a sin
g
le output model the number n will not be displayed.
4.4.1 Selectin
g
an output channel
Make an output channel active as follows.
If you have a sin
g
le output model, skip the first three lines of the followin
g
sequence.
Press to select the desired output channel.
The display then shows the selected output channel.
Press to enable the selected output (if not already enabled).
The display shows:
Press to set the power supply to OPERATE mode.
The display shows:
LCL
OPR/STBY
SELECT
ENABLE
DISABLE
n STANDBY
ENABLED n
OPR
STBY
n xx.xxV
ENABLED n
yy.yyA