Filter
Top Products
IDL series User Guide
208
Output Fields:
Field Description
MacAddress
The MAC address used by this bridge, when it must be
referred to, in a unique fashion. It is the address of one of the
Ethernet ports.
No. of Ports
The maximum number of ports that can be controlled by this
bridge.
Base Type
Indicates what type of bridging this bridge can perform. It is
always Transparent Bridging or STP.
Aging TimeOut
The timeout period, in seconds, for aging out dynamically
learned forwarding information from CPEs. The value 0 can
be configured when aging is to be stopped.
Slaveaging TimeOut
The timeout period, in seconds, for aging out dynamically
learned forwarding information learned from the slave device.
The recommended value for this is more than or equal to the
value for dot1dTpAgingTimeOut. The value 0 can be
configured when aging is to be stopped.
Floodsupport
This is used to specify whether the unknown unicast packets
are to be flooded or not. The value for this is used along with
per vlan configuration for flood support to determine if
flooding has to be done for unknown unicast packet.
Bcastsupport
This is used to specify whether the broadcasting is supported
or not. The value for this is used along with per vlan
configuration broadcast support, to determine if broadcasting
has to be done for the broadcast packet.
Mcastsupport
Used to specify whether the multicast is supported or not.
Mcastdrop
Used to specify whether the multicast packets are to be
dropped, or to be forwarded, if multicast is not supported.
This is only valid if dot1dTpMcastSupport is false.
NetAgingTimeout
The timeout period, in seconds, for aging out dynamically
learned forwarding information from NET side port. This is
used only for full bridge configuration. The recommended
value of net aging timeout should be greater than that of
dot1dTpAgingTimeOut.
Full Bridging Status
This specifies the current state of full bridging on the bridge.
Thebridge can be set to residential bridging, restricted full
bridging or unrestricted full bridging. In residential bridging, all
packets from a CPE side port are sent to Net side port without
doing a lookup in the forwarding table. In restricted full
bridging, there is a lookup and a packet coming from a CPE