Filter
Top Products
IDL series User Guide
284
<atucintlmintxrate-val>
Also refer to 'adslAtucConfRateChanRatio' for information regarding
RADSL mode and refer to ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucfastmaxtxrate
<atucfastmaxtxrate-val>
Configured Maximum Transmit rate for 'Fast' channels, in bps. Also
refer to 'adslAtucConfRateChanRatio' for information regarding RADSL
mode and ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucintlmaxtxrate
<atucintlmaxtxrate-val>
Configured Maximum Transmit rate for 'Interleave' channels, in bps.
Also refer to 'adslAtucConfRateChanRatio' for information regarding
RADSL mode and ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucmaxintldelay
<atucmaxintldelay-val>
Configured maximum Interleave Delay for this channel. Interleave
delay applies only to the interleave channel and defines the mapping
(relative spacing) between subsequent input bytes at the interleaver
input and their placement in the bit stream at the interleaver output.
Larger numbers provide greater separation between consecutive input
bytes in the output bit stream, allowing for improved impulse noise
immunity at the expense of payload latency.
Type: Modify -- Optional
Valid values: 0 - 255
type noChannel | fastOnly |
interleavedOnly |
fastOrInterleaved |
fastAndInterleaved
This object is used to configure the ADSL physical line mode.
Type: Modify -- Optional
atucgstxendbin
<atucgstxendbin-val>
The highest bin number allowed for Tx signal.
Type: Modify -- Optional
Valid values: 0x06 -
0xff
atucgstxstartbin
<atucgstxstartbin-val>
The lowest bin number allowed for Tx signal.
Type: Modify -- Optional
Valid values: 0x06 -
0xff
atucgsmaxbitsperbin
<atucgsmaxbitsperbin-val>
The maximum Rx number of bits per bin.
Type: Modify -- Optional
Valid values: 0 - 15
atucgsrxstartbin
<atucgsrxstartbin-val>
The lowest bin number allowed for Rx signal.
Type: Modify -- Optional
Valid values: 0x01 - 0x1ff
atucgsrxendbin
The highest bin number allowed for Rx signal.