Filter
Top Products
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
428
radius-server key Sets the RADIUS encryption key GC
radius-server retransmit Sets the number of retries GC
radius-server timeout Sets the interval between sending authentication requests GC
show radius-server Shows the current RADIUS settings PE
Table 5-30 RADIUS Client Commands
radius-server host
This command specifies primary and backup RADIUS servers and authentication parameters that apply to each server. Use the
no form to restore the default values.
Syntax
[no] radius-server index host {host_ip_address} [auth-port auth_port] [acct-port acct_port] [timeout timeout] [retransmit
retransmit] [key key]
index - Allows you to specify up to five servers. These servers are queried in sequence until a server responds or the
retransmit period expires.
host_ip_address -IP address of server.
auth_port - RADIUS server UDP port used for authentication messages. (Range: 1-65535)
acct_port - RADIUS server UDP port used for accounting messages. (Range: 1-65535)
timeout - Number of seconds the switch waits for a reply before resending a request. (Range: 1-65535)
retransmit - Number of times the switch will try to authenticate logon access via the RADIUS server. (Range: 1-30)
key -Encryption key used to authenticate logon access for client. Do not use blank spaces in the string. (Maximum length:
48 characters)
Default Setting
auth-port - 1812
acct-port - 1813
timeout - 5 seconds
retransmit - 2
Command Mode
Global Configuration
Example
Console(config)#radius-server 1 host 192.168.1.20 auth-port 181 timeout
10 retransmit 5 key green
Console(config)#