Filter
Top Products
PC Configuration
11
Setup Wizard
The first time connecting to XRT-401B, Setup Wizard will show up at home page
automatically. (Setup Wizard will also run if XRT-401B's default settings are restored.)
1. Ensure the Cable/DSL modem is connected and powered ON.
Also, you need the data provided by your ISP.
2. Start the Wizard, and step through it until finished.
It is required to know the type of Internet connection service used by your ISP.
The common types are explained below.
Figure 3-1: Home Screen
PPPoE Connection for WAN
If your ISP uses PPPoE (Point-to-Point Over Ethernet) to establish communications
with end-users, you will receive information such as User Name and Password from
them. To set up a PPPoE connection for WAN, follow the instructions as shown in
Figure 3-1 Cable/DSL Setup Menu Screen and Figure 3-2 Cable/DSL Setup Menu
with “No” Option Screen. Then, it is required to configure following values to make
your router work. (See Figure 3-3 PPPoE Menu Screen)
-User Name and Password: Fill in the entries with the information you get from your
ISP.
-Service Name: If your ISP provides this info, please type it into the field.
-Connect on Demand: If you have been disconnected due to inactivity,
Connect on Demand will enable you to establish a connection again between your
Router and ISP.
-Max Idle Time: The Max Idle time is the amount of time you would like to pass before
the Router drops your Internet connection due to inactivity. Enter zero (0) in the field
to remain Internet connection on at all time. The idle time ranges from 0 to 60
minutes.