Filter
Top Products
E – 14
The supplied remote mouse receiver enables you to operate your computer's mouse functions from the remote control. It is a
great way to control your computer-generated presentations.
• The cursor key on the remote control operates the computer mouse functions.
• If a Windows computer is connected, the L-CLICK button on the remote control operates as the
computer mouse left click button and the R-CLICK button as the computer mouse right click button.
• If the Macintosh computer is connected, the L-CLICK and R-CLICK buttons operate in the same way
as the computer mouse click button.
• While the menu is displayed on the screen (see page 21), the cursor key, L-CLICK and R-CLICK
buttons will operate to control the menu.
Before connecting
• Turn off the computer, then remove the current mouse.
• Connect the unit and remote mouse receiver with the supplied wired remote control cable as shown in the above illustration.
• The unit and computer will be turned on as described in “Using the Data Projector” on page 16. Do not turn on either the computer or unit
until you read this section.
• Please also refer to the manual of the computer to be connected.
Connecting the remote mouse receiver to an IBM PC/AT computer
Connect the IBM/Mac connector on the remote mouse
receiver and PC’s mouse port with the supplied serial
cable.
Connecting the remote mouse receiver to an IBM PS/2 or Macintosh computer
Connect the supplied serial cable to the IBM/Mac con-
nector on the remote mouse receiver.
Connect the supplied mouse adapter to the other end of
the serial cable and the computer mouse port. Note that
two types of mouse adapters are supplied; one is for
IBM PS/2 and the other is for Macintosh.
Another use of the remote mouse receiver
Connect the remote mouse receiver only to your computer
following the above instructions. The remote control can be
used to operate the computer mouse functions even if the
remote mouse receiver is not connected to the Data Projector.
Point the remote control to the remote mouse receiver while
operating.
Using the remote control as a computer
mouse – Wireless mouse function
Serial mouse
cable (supplied)
Wired remote
control cable
(supplied)
Connect to
the EXT.IR
jack on the
remote
mouse
receiver
Connect to
the REMOTE
OUT jack on
the unit
Connect to
the IBM/Mac
connector
(see below)
Connectors of the remote
mouse receiver
Remote mouse receiver
Serial mouse cable
(supplied)
IBM PC/AT
To the IBM/Mac connector
Remote mouse receiver
Serial mouse cable
(supplied)
IBM PS/2 or
Macintosh
To the IBM/Mac connector
Mouse adapter for IBM PS/2 (supplied) or
Mouse adapter for Macintosh (supplied)
PLUS
IBM/Mac EXT.IR