Filter
Top Products
MGC-50/MGC-100 Getting Started Guide
8-10
For more information about viewing card parameters, see MGC Manager
Administrator’s Guide, Chapter 4.
Clock This column is valid only for ISDN and Serial (MPI-8)
Network Interface cards.
On the Net-2/Net-4/Net-8 Network Interface Module,
the Master and the Backup clocks can be set on any
of the spans connected to the module.
This column indicates which Network card/span is
used as the Master Clock and which one is used as
the Backup clock.
Configured Clock Indicates which ISDN Network card or MPI Span
was configured as the Primary network interface (for
clocking), and which one is used as backup.
Changes take effect and are updated during the next
MCU reset or power up.
Status Indicates the card status; Normal or Faulty.
Occupied Units Indicates the units on the card that are currently
used to run conferences. For example, 1, 6 indicates
that two units, unit # 1 and unit # 6 are used to run
conferences.
Faulty Units Indicates if there are units on the card which are
faulty and the sequential number of the faulty unit.
Disabled Units Indicates the units that were disabled by the
operator.
Num Units Indicates the total number of units available for each
module.
Table 8-2: MCU's Cards Status Columns
Field Description