Filter
Top Products
Chapter 3 - Initial System Configuration
3-15
The Spans and Phones dialog box opens.
This dialog box is used to assign circuit identification numbers and the
dial-in phone number ranges to be used in dial-in conferences. Circuit
orders are automatically assigned to spans. If only one service provider is
used, define all the PRI lines here.
The dial-in phone numbers are allocated to the MCU by the service
provider (carrier) and should be obtained from the service provider.
To define
a span
To define a dial-in phone
numbers range
To delete a
currently
defined dial-in
numbers range
To allocate
dial-in numbers
for Gateway
calls
To delete
allocated dial-in
numbers for
Gateway calls
The number used
to identify the
MCU
To remove a
span