Chapter 3 - Initial System Setup
3-3
Installing the MGC Manager
To set up conferences and to control the MGC unit you must install the MGC
Manager software on a PC. Up to 30 MGC Manager-enabled PCs can be
connected to each MGC-25. A single MGC Manager-enabled PC can manage
multiple MGC systems.
During the installation, default Reservation templates are installed.
To install the MGC Manager software:
1. Insert the software CD into the CD drive.
2. On the Start menu, click Run.
The Run dialog box opens.
3. Type D:\SETUP (where D is the name of the CD drive), and then click
OK.
The installation wizard starts and the License Agreement window opens.
The MGC-25 is shipped with a default IVR Service, default Entry
Queue Service, and a default conference profile. For information
about restoring these services when upgrading MCU software, refer
to the MGC Administrator’s Guide, Chapter 5.
Installing the
MGC Manager
Initial IP
Configuration
Connecting
to an MCU
Configuring the
Network Services
Defining an MCU
Starting the MGC
Manager