Filter
Top Products
10
Po werware 9315 Maintenance Bypass Module 30-160kVA
164201177 Rev. C 041500
FRONT SIDE
SUPPORT
SUPPORT
1
1
2
JACKING BOLT
FLOOR
PROTECTOR
1
2
DOOR
REAR
SUPPORT
(USE FRONT AND REAR)
(4 PLACES)
POLYFOAM
SKID
POLYFOAM
SKID
Figure 4. Detail of Shipping Supports
6. Carefully and evenly lower the MBM by turning each jacking bolt
counterclockwise in sequence no more than two full turns e ach (maximum)
until the supports contact the floor, and the module is no longer supported by
the jacking bolts.
7. When the module is resting on the floor, remove the jacking bolts. Discard or
recycle them in a resp onsible manner.
8. Removethehardwarelabeled“2”inFigure4,holdingthefront,rearandside
supports to the module base (14 places). Discard o r recycle the hardware and
support brackets in a responsible manner.
9. Install the doors removed in step 1. The MBM is now ready to be rolled to its
final location.