Filter
Top Products
Operation
14
Powerware
®
9120 User's Guide S 05147426 A Uncontrolled Copy
Display Mode
To view the UPS current settings, press the button for one second. Use
the
button to scroll through the list of settings:
LCD Message Description
I/P VOLT= xxx.xV Input voltage.
I/P FREQ= xx.xHZ Input frequency.
O/P VOLT= xxx.xV Output voltage.
O/P FREQ= xx.xHZ Output frequency.
O/P Load = x% Approximate percentage of UPS load capacity being used by the
protected equipment.
O/P Watt= xW Output watts.
O/P VA= xVA Output VA.
O/P Cur= x.xA Output current.
BAT VOLT= xx.xV Battery voltage.
BAT CHARGE= xxx% Approximate percentage of battery capacity remaining.
BackUp Time= xxxM Approximate battery time remaining in minutes. The display changes
to seconds after one minute (Backup Time= xxxS).
CPU Version x.xx Firmware revision level.
NOTE The UPS exits Display mode automatically after five seconds if the button is
not pressed.
Turning the UPS On
After the UPS is connected to a power source, the fan turns on and
the UPS enters Standby mode. To turn on the UPS, press and hold
the
button until you hear the UPS beep (approximately one second).
The LCD briefly displays
On Delay and the
indicator illuminates.
Then the UPS conducts a selfĆtest, briefly displaying
On BATTERY. If an
alarm condition occurs, see Table 10 on page 37.
When the self-test is complete, the LCD displays
On Line indicating that
power is available from the UPS output receptacles.