Q-Logic 16-Feb Switch User Manual


 
B – Command Line Interface
Commands
59021-04 C B-3
Q
B.3
Commands
The command set provides for User and Admin authority levels.
User authority grants viewing access to the fabric and switches using the
Show command and other read-only commands.
Admin authority includes the User authority and grants permission to use the
Admin command. The Admin Start command opens an admin session which
provides access to the commands that change switch and fabric
configurations. Refer to the ”Admin Command” on page B-4.
The commands and their page numbers are listed by authority level in Table B-1.
Note: Admin authority is enforced only if fabric security is enabled. By
default, fabric security is disabled. Refer to ”Set Setup Command” on
page B-37 (System keyword) for more about setting fabric security.
Table B-1 Commands Listed by Authority Level
User Authority Commands Admin Authority Command
Help
History
Ps
Quit
Show
Show Config
Show Log
Show Perf
Show Setup
Uptime
Whoami
(B-11)
(B-12)
(B-16)
(B-17)
(B-41)
(B-54)
(B-57)
(B-59)
(B-61)
(B-68)
(B-71)
Admin (B-4)
Admin Session Commands
Alias
1
Config
1
Date
1
Fallback
Image
Lip
Passwd
Reset
Set
1
Set Config
Set Log
Set Port
Set Setup
Shutdown
Test
User
1
Zone
1
Zoneset
1
Zoning
1
1
Some keywords are available with User authority.
(B-5)
(B-7)
(B-9)
(B-10)
(B-13)
(B-14)
(B-15)
(B-18)
(B-23)
(B-25)
(B-33)
(B-36)
(B-37)
(B-64)
(B-65)
(B-69)
(B-72)
(B-76)
(B-79)