Filter
Top Products
B – Command Line Interface
Set Setup Command
59021-05 B B-39
Q
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-12 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is
False.
ProxyEnabled Enables (True) or disables (False) SNMP communication
with other switches in the fabric. The default is True.
Table B-12. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
RARP)
Eth0NetworkAddress Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask Subnet mask address for the Ethernet port.
Eth0GatewayAddress IP address gateway.
AdminTimeout Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
TempMonitoringWarning Warning temperature threshold in °C above which
a warning condition alarm is generated. The
default is 65 °C.
TempMonitoringFailure Failure temperature threshold in °C above which a
failure condition alarm is generated. The default is
70 °C.
TempFailurePortShutdown Enables (True) or disables (False) the switch’s
ability to place all ports offline when the internal
temperature exceeds the failure threshold. The
default is False.
Table B-11. SNMP Configuration Settings
Entry Description