Filter
Top Products
B – Command Line Interface
Set Setup Command
B-40 59021-05 B
Q
Notes The two components of security are user authentication and fabric security. The
user must be authenticated before gaining access to a switch. If an invalid
account name/password combination is entered, that user can not access the
switch, and thus can not gain access to the fabric. If security is enabled (True) and
a valid account name/password combination is entered, that user can access the
switch but can not execute any command that exceeds their authority (privileges)
level. If security is disabled (False) and a valid account name/password
combination is entered, that user has access to all switches in the fabric and can
execute all commands (both user and admin), regardless of their authority
(privilege) level.
Examples The following is an example of the Set Setup SNMP command:
SANbox2 #> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency, alert, critical, error, warning, notify, info, debug, mark
Contact (string, max=32 chars) [<sysContact undefined]
Location (string, max=32 chars) [sysLocation undefined]
Trap1Address (dot-notated IP Address) [10.20.71.15 ]
Trap1Port (decimal value) [162 ]
SecurityEnabled Enables (True) or disables (False) the enforcement
of account names and passwords. The default is
False.
LocalLogEnabled Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the
switch event log information if remote logging is
enabled. The default is 10.0.0.254.
Table B-12. System Configuration Settings (Continued)
Entry Description