Q-Logic 59021-05 B Switch User Manual


 
B – Command Line Interface
Show Command
B-46 59021-05 B
Q
LIP_F7_F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIP_F8_F7 A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization for a period of time
greater than the value of R_T_TOV or by loss of signal
while not in the offline state. A loss of signal causes the
switch to attempt to re-establish the link. If the link is not
re-established by the time specified by R_T_TOV, a link
failure is counted. A link reset is performed after a link
failure.
Login Time when the port logged in.
Logout Time when port logged out.
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
RxLinkResets Number of link reset primitives received from an attached
device.
RxOfflineSeq Number of offline sequences received. An OLS is issued
for link initialization, a Receive & Recognize
Not_Operational (NOS) state, or to enter the offline state.
TotalErrors Total number of errors detected.
TotalLIPsRecvd Number of loop initialization primitive frames received by
this port.
TotalLinkResets Total number of link reset primatives.
TotalOfflineSeq Total number of Offline Sequences issued by this port.
TotalRxFrames Total number of frames received by this port.
TotalRxWords Total number of words received by this port.
TotalTxFrames Total number of frames issued by this port.
TotalTxWords Total number of words issued by this port.
Table B-13. Show Port Parameters (Continued)
Entry Description