Q-Logic 8200 Network Cables User Manual


 
1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
1-8 SN0054671-00 A
Adapter Configuration (CNA/IEA Function Configuration
Utility)
This section provides detailed configuration information for advanced users who
want to customize the configuration of the 10Gb adapter and the connected
devices. You can configure the adapter using the CNA Function Configuration
utility.
To access the CNA Function Configuration utility, press ALT+ Q during the
adapter initialization (it may take a few seconds for the menu to appear). If you
have more than one adapter, the utility will ask you to select the adapter you want
to configure. After changing the settings, the utility reboots your system to load the
new parameters.
Upon entering the CNA Function Configuration utility, the following selections are
available from the Setup Menu/Function Configuration menu:
Function
Type
MinBW%
Protocol
Restore to Non-NIC Partition Settings
Exit the CNA Function Configuration Utility
NOTE:
If you used an FC RAID target in a cluster environment, you should
enable the Enable Target Reset = Enabled (Advanced
Adapter Settings).
Use the /I option if the update utility, QLflash, does not detect your
adapter.
QLogic recommends disabling the internal disk before installing the OS
or booting to the FCoE disk.
NOTE:
The CNA Function Configuration utility does not run on SUN™ SPARC
®
systems.
CAUTION!
If the configuration settings are incorrect, your adapter may not function
properly.