Filter
Top Products
2–Configuring NIC
Configuring Driver Software Parameters
SN0054671-00 A 2-7
qaucli Utility
Install QConvergeConsole CLI (qaucli) from the following packages supplied by
QLogic:
QConvergeConsoleCLI-<version>_linux_<arch>.install.tar.gz—
Package file
QConvergeConsoleCLI-<version>_<arch>.rpm—RPM installer
package file
Example RPM package installation:
To determine if QCC is installed and to find the full name of the installed QCC
RPM package, issue the following command using the partial name
QConvergeConsoleCLI as an argument to grep:
rpm –qa | grep QConvergeConsoleCLI
1. To check for an older version of the RPM package, issue the following
command:
rpm –qa QConvergeConsoleCLI
2. If an older version is found, erase that version by issuing the following
command:
rpm –e QConvergeConsoleCLI
3. To install the new version, issue the following command:
rpm –ihv QConvergeConsoleCLI-1.0.00-04.i386.rpm
The utility is installed in the
/opt/QLogic_Corporation/QConvergeConsoleCLI directory.
ethtool Utility
Use the ethtool utility to view adapter statistics and configure interface options.
For additional details, refer to qlcnic driver man page and ethtool man page.
Examples:
To disable transmit segmentation offload, issue the following command, where
[n] represents a numerical value for a specific instance:
ethtool -K eth[n] tso off
To list interface statistics, issue the following command, where [n] represents a
numerical value for a specific instance:
ethtool –S eth[n]