Filter
Top Products
40
Operation
Copying a Frequency into a Vacant
Channel in a Specified Bank
You can copy a frequency into a vacant channel in a
specified bank when the scanner stops on the frequency
during search or tune mode.
1. Press
FUNC
then
ENTER
when you find a frequency
you want to copy.
â8EBéý
â8EBéýâ8EBéý
â8EBéý/K
/K/K
/KFI<å
FI<åFI<å
FI<å
appears.
2. If you want to copy the frequency into bank 9, press
ENTER
. It is stored in the first available vacant chan-
nel in the bank. Or, press your desired bank number
to store, then press
ENTER
.
á?8Eý /KFI<ü
á?8Eý /KFI<üá?8Eý /KFI<ü
á?8Eý /KFI<ü
appears
for 2 seconds. All the conditions such as receiving
mode and delay condition are copied on the chan-
nel. After about 2 seconds, the scanner automati-
cally returns to search mode.
3. If you try to copy a frequency which is already
stored, the scanner sounds the notice tone 3 times
after you press
ENTER
.
LGCô=ýá?OOO
LGCô=ýá?OOOLGCô=ýá?OOO
LGCô=ýá?OOO
appears at the
bottom line. If you want to copy the duplicate fre-
quency anyway, press
ENTER
, or if not, press
CL
to
cancel.
Copying a Frequency into the Priority
Channel
You can copy a frequency into the priority channel (see
“Priority” on Page 44) when the scanner stops on the fre-
quency during Search, Scan, Manual, Tune, or WX
mode.
Press
FUNC
then
PRI
when the frequency is on the dis-
play. The display flashes twice and the frequency is cop-
ied to the priority channel.
SCANNING THE CHANNELS
To begin scanning channels or to start scanning again
after monitoring a specific channel, press
SCAN
.
Note:
You must store frequencies into channels before
the scanner can scan them. The scanner does not scan
through empty channels.