Filter
Top Products
54
Trunking Operation
8
88
8
to access the next open channel then enter the
frequencies. (See “Storing Known Frequencies into
Channels” on Page 25).
7. Press
SCAN
to start scanning.
Notes:
• If you make an error in the entry process, press
CL
as often as needed to erase the incorrect data.
• If you enter a frequency that has already been
entered, the scanner sounds an error tone and dis-
plays
LGCôý=
LGCôý= LGCôý=
LGCôý=
and the channel number that has been
duplicated. If the dual entry is an error press
CL
and
enter the correct frequency. If the dual entry is inten-
tional press
ENTER
to accept.
• You may replace any frequency by selecting the
bank and channel, pressing
PGM
and entering the
new frequency.
Programming Motorola Trunking Systems
(UHF-Lo)
You can program the scanner to receive transmissions
in the UHF-Lo band (406-512 MHz) of the Motorola
trunking system. You can receive these transmissions
by checking the trunking system's control channel. You
must program the system's base frequency and offset
frequency to do this.
Notes:
• Base and offset frequencies vary for each type of
trunking system. You can get information about
these frequencies for the trunking system you want
to scan using
www.trunkscanner.com
, other Internet
sources, or locally-published guidebooks.
,òòñUôô
,òòñUôô,òòñUôô
,òòñUôô ôö")
ôö") ôö")
ôö")
òôòòòòò
òôòòòòòòôòòòòò
òôòòòòò
â8EBýòý
â8EBýòýâ8EBýòý
â8EBýòý á?ýòñ
á?ýòñá?ýòñ
á?ýòñ
Next channel