Filter
Top Products
47
Special Features
!
! !
!
— accesses the FM Mode, EDACS Trunking System
(with 4-digit decimal ID code or 5-digit AFS code)
Note:
MO (MOT) and ED modes are not available when
the scanner tunes up or down through the frequency
ranges in which the trunking operation is not used.
USING THE ATTENUATOR
To reduce interference or noise caused by strong sig-
nals, you can reduce the scanner's sensitivity to these
signals.
There are two attenuator modes in your scanner. One is
normal attenuator mode in which you set the attenuator
in each channel or each band/group in the search and
tune mode. The other is global mode in which you set
the attenuator only once. This setting is applied all the
time in every mode.
Press
ATT
to turn on or off the attenuator while the chan-
nel number is indicated or while the scanner is searching
through bands/groups. When the attenuator is on,
ã
ãã
ã
ap-
pears at the seventh digit in the top line.
When you turn it off,
ã
ãã
ã
changes to "
ô
ôô
ô
". You cannot set the
attenuator while the scanner is scanning.
Press
FUNC
then
ATT
to set the attenuator to the global
mode.
#CF98Cýã00ô
#CF98Cýã00ô#CF98Cýã00ô
#CF98Cýã00ô
appears for 2 seconds at the bottom
line and
W
WW
W
or
#
##
#
appears.
W
WW
W
means the attenuator is on and
#
##
#
means off. Press
ATT
to turn on or off the attenuator.
ã00FE
ã00FEã00FE
ã00FE
or
ã00V
ã00Vã00V
ã00Vý
appears on the bottom line while scan-
ning.
Press
FUNC
then
ATT
again to turn off the global attenu-
ation mode.
*FID8Cýã00
*FID8Cýã00*FID8Cýã00
*FID8Cýã00
is indicated at the bottom line for
2 seconds.
Note:
If you turn on the attenuator, the scanner might
not receive weak signals.