Filter
Top Products
58
Trunking Operation
6. Press
ENTER
for each entry. If you make a mistake,
press
CL
and enter the correct size code.
Notes:
• The default setting of the bank is for Motorola
Type II. However, if you set Type I and you want
to return to Type II, enter 15 at Step 5.
• To confirm the input, repeat Steps 1–5 and press
ENTER
. Each time you press
ENTER
, you confirm
the size code. If you find an error, press
CL
and
begin again at Step 1.
7. Press
SCAN
to start scanning.
Talk Group IDs
There are 10 talk group ID banks and each ID bank has
5 sub-banks. Each sub-bank has 20 ID locations. You
can program up to 100 talk group IDs in each bank, so
you can program up to 1,000 talk group IDs in 10 banks.
When the scanner stops on a transmission in the Motor-
ola, or EDACS mode, it checks to see if the ID has been
stored. In the closed mode, the scanner only stops on
the transmission and displays its text tag if you have
stored and not locked out the ID. In the open mode, the
scanner always stops on a transmission, but it displays
the ID's text tag if you have stored the ID.
Storing Talk Group IDs
To store a talk group ID, press
TRUNK
when the scanner
stops on a voice channel transmission or when a talk
group ID is indicated in the manual mode. The bottom
line indicates where the ID was stored as
% ýJ8M<ý4
% ýJ8M<ý4% ýJ8M<ý4
% ýJ8M<ý4V4
V4V4
V44
44
4
and then changes to
ý
ýý
ý% û4444
% û4444% û4444
% û4444
.
7 S0S4S0S4S0———
Block
Size Code
910111213141516