Filter
Top Products
30
Using the Remote
You’ll use these buttons when you
program the remote.
The remote may not operate all models
of all brands.
PLAY
REVERSE
STOP
VCR1
ON • OFF
TV
DVD
VCR2
AUX
DIRECTV
Programming the Remote
Using Automatic Code Search
The following instructions can be used to program the remote to control
each of the devices connected to your monitor. If you want to exit the
automatic code search without programming any of your devices, press
and hold CLEAR until the LED turns off.
1. Turn on the device you want to control (VCR, digital satellite
receiver, etc.).
2. Press and hold the button you want to program (VCR1, DIRECTV,
etc.). While holding the device button, press and hold ON•OFF until
the red light on the remote turns on, then release both buttons.
3. Point the remote at the device, press and release PLAY, then wait 5
seconds or until the LED stops flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds or until the LED stops flashing, the
device you want to control does not turn off, press PLAY again to
tell the remote to search the next set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are 20 total sets of codes. If
the device does not turn off after pressing PLAY 20 times, then the
remote cannot control that particular device.
If the device you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step
until the device turns back ON.
2. To finish, press and hold STOP until the red light on the remote
turns off.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the
code list on the last page of this section.
3. Press and hold the button on the remote you want to program.
4. Enter the code from the code list.
5. Release button, and then press ON•OFF to see if the component
responds to the remote commands. If it doesn’t, try pressing the
component button and then ON•OFF again.
6. If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
commands.
LED