Filter
Top Products
( 19 / 78 )
2.2 Package Components
The M30620T2-RPD-E package consists of the following items. When unpacking, check to see if
your M30620T2-RPD-E contains all of these items.
Please keep the M30620T2-RPD-E’s packing box and cushion material in your place for reuse at a
later time when sending your product for repair or other purposes. Always use these packing box and
cushion material when transporting this product.
If any of these items are missing or found faulty, please contact your local distributor. Also, if there
is any question or doubt about the packaged product, contact your local distributor.
2.3 Other Tool Products Required for Development
To bring forward programs development on the M16C/62 and 62A Group MCUs, the products listed
below are necessary in addition to those contained package above. Get them separately.
To purchase these products, contact your nearest distributer.
Item
M30620T2-RPD-E emulation pod main unit
FLX120-RPD flexible cable for connecting PC4701
FLX100 flexible cable for connecting pitch converter board (pre-installed in emulation pod)
FLX-100LCC pitch converter board for connecting target system
OSC-3 (16 MHz) oscillator circuit board (pre-installed in emulation pod)
OSC-2 oscillator circuit board
Resistor arrays for pulling up ports P00 to P57 (51 kΩ)
Hardware tool user registration FAX sheet (English)
Hardware tool user registration FAX sheet (Japanese)
M30620T2-RPD-E user's manual (this manual)
M30620T2-RPD-E user's manual (Japanese)
Quantity
1
1
1
1
1
1
12
1
1
1
1
Emulator main unit
Emulator debugger
PC4701M, PC4701HS or PC4701L
M3T-PD30
FLX-DIRECT613 + DIRECT80S
or
100LCC-80QSB
see Figure 3.11 Connecting emulation pod and target systems
(page 35)
Converter board
(Required for 80-pin MCUs)