Renesas M30620T2-RPD-E Switch User Manual


 
( 24 / 78 )
Chapter 3. Setting Up
To use this emulation pod with your target system, it is necessary to set as follows. Set the following
after removing the upper cover.
• Change the oscillation frequency.
• Set the XIN, XOUT, XCIN and XCOUT pins for the target system.
• Set the switches for the operating voltage of the target system.
• Install a pullup resistor to ports P00 to P57.
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
(1) Remove the four screws of both sides of this product and lift off the upper cover. (see Figure 3.1)
(2) Set the jumper switches.
(3) Replace the upper cover and secure the four screws.
Figure 3.1 Removing the upper cover
CAUTION
When Removing the Upper Cover:
Always shut OFF power when removing the upper cover or setting the switches.