Renesas M30620T2-RPD-E Switch User Manual


 
( 52 / 78 )
Figure 5.5 Timing requirements
VCC = 5 V
Common to "with wait" and "no-wait" (actual MCU)
BCLK
Common to "with wait" and "no-wait" (This product)
BCLK
Note 1. P00 to P52 will be high-impedance status regardless of the input level of BYTE pin and
ports P40 to P43 function selection bit (PM06) of the processor mode register 0.
Note 2. This product will be high-impedance delaying by 2.5 cycles than an actual MCU.
Note 3. The setup time of HOLD is defined by the startup of BSLK, differently from that of
actual MCUs.
Conditions:
• V
CC =5 V
• Input timing voltage: VIL = 1.0 V, VIH = 4.0 V
• Output timing voltage: VOL = 2.5 V, VOH = 2.5 V
P0, P1, P2,
P3, P4,
P50 to P52
HOLD input
HOLD input
P0, P1, P2,
P3, P4,
P50 to P52
HLDA output
HLDA output