Filter
Top Products
System Settings
48
2
❖ SMB Work Group
Specify the SMB work group.
Enter the group name using up to 15 characters.
"*+,/:;<>=?[\]|. and spaces cannot be entered.
Use uppercase letters for alphabet.
❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your network environment. [Auto Select] should
usually be selected.
The default setting is Auto Select.
• Setting the Ethernet Speed
Confirm your network environment, and then select a speed that matches
it using the following table.
❖ LAN Type
When you have installed the optional IEEE 802.11b interface unit, select the
method of connection.
The default setting is Ethernet.
[LAN Type] is displayed when wireless LAN board is installed. If Ethernet and
IEEE 802.11b (wireless LAN) are both connected, the selected interface has
priority.
❖ Ping Command
Check the network connection with ping command using given IPv4 address.
If you fail to connect to the network, check the following, and then retry the
ping command.
• Make sure that "IPv4" in [Effective Protocol] is set to "Active".
• Check that the machine with assigned IPv4 address is connected to the net-
work.
• Check if the same IPv4 address is used for the specified equipment.
Router/
HUB
Machine
10Mbps Half
Duplex
10Mbps Full
Duplex
100Mbps
Half Duplex
100Mbps
Full Duplex
Auto Select
10Mbps Half
Duplex
b ---b
10Mbps Full
Duplex
- b ---
100Mbps
Half Duplex
--b - b
100Mbps
Full Duplex
---b -
Auto Select b - b - b