Ricoh 161F All in One Printer User Manual


 
Interface Settings
51
2
IEEE 802.11b
This section describes various items of [IEEE 802.11b] under [Interface Settings].
This section describes the user tools in the IEEE 802.11b menu under Interface
Settings. [IEEE 802.11b] is displayed when this machine is installed with the wire-
less LAN interface board.
Be sure to make all settings simultaneously.
Communication Mode
Specifies the communication mode of the wireless LAN.
The default setting is 802.11 Ad hoc.
SSID Setting
Specifies SSID to distinguish the access point in infrastructure mode or 802.11
ad hoc mode.
The characters that can be used are ASCII 0x20-0x7e (32 bytes). If blank is
specified in 802.11b ad hoc mode or ad hoc mode, "ASSID" appears.
Channel
The default setting is 11.
The following channels are available:
1-14 (Metric version) / 1-11 (Inch version)
Security Type
Specifies the encryption of the IEEE 802.11b (wireless LAN).
If you select [WEP], always enter WEP key. If you select [WPA], specify the en-
cryption and authentication methods.
Specify "WPA", when [Communication Mode] is set to [Infrastructure].
The default setting is Off.
•Off
•WEP
•WPA
•Encryption Method
Select either "TKIP" or "COMP(AES)".
Authentication Method
Select either "WPA-PSK" or "WPA(802.1X)".
If you select "WPA-PSK", enter the pre-shared key (PSK) using 8-63 AS-
CII characters.
Wireless LAN Signal
When using in infrastructure mode, you can check the machine's radio wave
status using the control panel.
Radio wave status is displayed when you press [Wireless LAN Signal].
Communication Speed
Specifies the communication speed of the IEEE 802.11b (wireless LAN).
The default setting is Auto.