Filter
Top Products
Connecting the Machine
14
1
❖ When using in ad hoc mode / 802.11 ad hoc mode
1. If the IEEE 802.11b interface unit is functioning, the LED lights up in or-
ange.
2. If it is connected properly to the network, the LED is green when in ad hoc
mode or 802.11 ad hoc mode. If the LED is blinking, the machine is searching
for devices. The LED will light after a few seconds.
Print the configuration page to verify settings.
Note
❒ For details about printing a configuration page, see "Print I/F Settings".
Reference
p.52 “Print I/F Settings List”
Checking the Signal
This section describes how to check the machine's radio wave status.
When using in infrastructure mode, you can check the machine's radio wave sta-
tus using the control panel.
A Select [System Settings] using {U} or {T}, and then press the {OK} key.
B Select [Interface Settings] using {U} or {T}, and then press the {OK} key.
C Select [IEEE 802.11b] using {U} or {T}, and then press the {OK} key.
D Select [Wireless LAN Signal] using {U} or {T}, and then press the {OK} key.
The machine's radio wave status appears.
E After checking radio wave status, press the {OK} key.
F Press the {User Tools/Counter} key to return to the User Tools/Counter menu.
Note
❒ For the procedure of entering the System Settings, see "Accessing User Tools".
Reference
p.4 “Accessing User Tools”
p.29 “Using Utilities to Make Network Settings”
p.51 “IEEE 802.11b”
ZGDH600J
1
2