Filter
Top Products
Fax Features
80
4
IP-Fax Settings
This section describes the user tools in the IP-Fax Settings menu under Fax Fea-
tures.
Default settings are shown in bold type.
Make settings to use IP-Fax.
Set H.323 for the gatekeeper, SIP for SIP server, and the gateway to G3 fax if nec-
essary. Check the settings of the network to which this machine is connected be-
fore making settings.
Make sure you enter these characters correctly:
•Numbers
•Symbols (# and *)
The following characters can be used for registration of the SIP
User Name in SIP Settings. Make sure you enter these characters correctly:
• Alphanumeric symbols (lower and upper cases)
• Symbols (;?:&=+$,-_.!~*#'@()%/)
Use numbers and periods (".") to enter the correct IPv4 addresses for the gate-
keeper, SIP server, and gateway. To obtain the correct IP addresses, consult ad-
ministrator.
❖ Enable H.323
Specify whether or not H.323 is used for IP-Fax transmission.
The default setting is Off.
❖ Enable SIP
Specify whether or not SIP is used for IP-Fax transmission.
The default setting is Off.
❖ H.323 Settings
Set the IP address or host name of gate keeper, and alias telephone number.
To use the gatekeeper, set the parameter setting list (switch 34, bit 0) to "On".
A Select [Fax Features] using {U} or {T}, and then press the {OK} key.
B Select [IP-Fax Settings] using {U} or {T}, and then press the {OK} key.
C Select [H.323 Settings] using {U} or {T}, and then press the {OK} key.
D Select [Gatekeeper Address (Main)] using {U} or {T}, and then press the {OK}
key.
E Enter the IPv4 address or host name of the gatekeeper, and then press the
{OK} key.
F Select [Own Fax No.] using {U} or {T}, and then press the {OK} key.
G Enter Own Fax No and then press the {OK} key.
H Press the {User Tools/Counter} key.