Filter
Top Products
32
Setting a Stack of Originals in the Document Feeder
You can insert a stack of originals into the document feeder. These originals are individually fed onto and
removed from the exposure glass (platen glass).
Note
❐ Some originals are unsuitable for the document feeder. ☛ See page 30.
❐ Do not press down or hold originals after inserting them.
❐ While originals are fed from the original table to the exposure glass (platen glass), do not pull them out.
❐ Do not lift the document feeder until the original has been completely fed out.
1
Correct any curl, fold, or crease in the originals
before setting the originals.
2
Make sure the Insert Original indicator is lit and
the exposure glass (platen glass) is clear of origi-
nals.
3
Adjust the guide to the original size.
4
Set the originals
face up
into the document
feeder until the Insert Original indicator goes
off.
Note
❐ The last page should be on the bottom.
❐ The original guide must touch the front side of the
originals.
❐ Do not stack originals above the limit mark.
Setting a Stack of Originals in the Document Feeder
TRSR050E
1: Limit mark
2: Original guide
2
1