Filter
Top Products
Print Server Manual 29 A741
7 A741 Repro Program
7.1 Introduction
The A741 Repro Software is not difficult to use. There are however a few
points which need some additional clarification. For a full description of the
program please consult the A741 Repro System Users manual.
7.2 Setting program options
The user can determine the behavior of the program by changing various
optional settings. The picture below shows the most important of these
settings.
1. Units of measurements
Set to desired units of measurement. This will effect the units of
measurement as shown by the A741 Repro program.
2. Use of pensets
Marking this option will use the pen information as defined in the HP-GL
or CalComp file. If marked optional pensets as defined in the project
window have no effect! To use custom pensets, disable this option. This
➊
➋
➌
➍
➎