Filter
Top Products
Print Server Manual 63 A741
bit 0 = (1) initialize data FIFOs, (0) no effect. These are the Littlebear on-board
FIFOs, not the PCI chip FIFOs. The on-board FIFOs will be cleared if this bit is
set to 1.
So, for example, if a 03 is the value entered, both of the above operations will be
performed. If 01 is entered, only the controller status byte will be cleared, and if
02 is entered, only the on-board FIFOs will be cleared. Any other value has no
effect at this time.
16.7 Command: “r”
This command is used to read a register from the controller address space. After
“r” is entered, LBTEST will prompt for the address to be read. A two-byte HEX
address is expected. For example, to read the register at address 8081h, enter
8081 when prompted for the register value. LBTEST will display the value of the
register just read.
16.8 Command: “s”
The status command is used to retrieve the status from the copier. The possible
status requests are as follows:
Engine default status (00h)
Current engine status (01h)
Output placement (02h)
print/scan status (10h)
Cover status (11h)
Paper misfeed status (12h)
Service call number (13h)
Scanner setting status (14h)
Command status (FFh)
All of the status requests are described in the interface document and will not be
described in detail in this document. In general, the user must enter the HEX
number corresponding to the status to be retrieved. LBTEST will display a line in
this format:
Success retrieving status: to_go:XX signals: YY sts: ZZ ZZ ZZ ZZ ZZ ZZ ZZ
ZZ ZZ
Where XX is currently not used (this information may be ignored), YY is the
controller status byte (described below), and ZZ are the status bytes from the
copier corresponding to the requested
status type (described in the interface spec).
The controller status byte is a bit-mapped byte that is set by the Littlebear
controller. The byte is mapped as follows:
bit 7 = Print/Scan underflow/overflow occurred.
bit 6 = Copier set command failure bit for last command.
bit 5 = Print/Scan did not complete successfully.
bit 4 = Command/Status communication failure between
controller/copier.
bit 3 = Controller computed checksum error in status from copier.