Filter
Top Products
Troubleshooting When Using the Copy Function
16
2
❖ Edit
❖ Combine
Problem Cause Solution
When using the Duplex
Margin function, parts
of the original image
are not copied.
You set a wide erased margin. Set a narrower margin with User
Tools. You can set the width be-
tween 0 - 50 mm (0" - 2").
See “Copier Features”, General
Settings Guide.
When using the Duplex
Margin function, parts
of the original image
are not copied.
There is a lack of margin space on
the opposite side of the binding
position.
Set a narrower margin with User
Tools. You can set the width be-
tween 0 - 50 mm (0" - 2").
See “Copier Features”, General
Settings Guide.
Problem Cause Solution
When using Combine,
parts of the image are
not copied.
You specified a reproduction ra-
tio that does not match the sizes
of your originals and copy paper.
When you specify a reproduction
ratio using the Manual Paper Se-
lect function, make sure that the
ratio matches your originals and
the copy paper.
(Select the correct reproduction
ratio before using the Combine
function.)
When using Combine,
parts of the image are
not copied.
Your originals are not identical in
size and direction.
Use originals that are identical in
size and direction.
Copies are not in cor-
rect order.
You placed the originals in the in-
correct order.
When placing a stack of originals
in the ADF or ARDF, the last page
should be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.