Filter
Top Products
Troubleshooting
81
Reset Toner
Cartridge
The toner cartridge is not set
correctly.
Set the toner cartridge correctly.
See p.39 “
Replacing the Toner Car-
tridge”.
The toner cartridge is not set in-
stalled.
If the cartridge is installed, close the
front cover and turn the off power
switch and then on. If the message
appears again, contact your sales or
service representative.
Reset Tray #
or Form Feed
The indicated paper input tray
is not set correctly, or not set.
#: tray number
Set the indicated paper input tray cor-
rectly.
Resetting Job... The print job is being reset. Wait for a while.
ROM Update
Waiting for Data
The printer is waiting for updat-
ed data.
Don't turn off the printer while it is wait-
ing for data.
ROM Update
Receiving Data
The printer is receiving updated
data.
Don't turn off the printer while it is re-
ceiving data.
SC XXX-X
Power Off On
If Error Reoccur
Call Service
An error has occurred. Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Supply order
failed
Supply order has failed. The use is required to reset the job.
SD authenticatn
failed
Authentication for the SD card
has failed.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Setting change
in process
A setting change is currently in
process on the computer side.
The user must wait until the change is
complete.
Setting changed
Restart Printer
[RAM Disk] or [Notify by E-mail]
setting has been changed.
Restart the printer so the new settings
can take effect.
SSID not entered This message appears if the
SSID has not been entered.
Enter the SSID.
Toner is almost
empty
The toner is almost run out. Prepare a new toner cartridge. If the
image density gets too light, replace
the toner cartridge with a new one.
See p.39 “
Replacing the Toner Car-
tridge”.
Update Mode Err.
Power Off On
The printer has failed to start
updating data.
Turn the power off, and then on to re-
start.
Waiting... The printer is waiting for the
next print job.
Wait a while.
Messages/Second
messages
Description Solution