Filter
Top Products
Installing Options
59
N Fasten the controller board to the printer with the two screws.
O Attach the antenna cap to the card with the side that has both corners
of the antenna cap cut out facing the screws.
P Align the power cable to the left side groove of the duplex unit, and then
slide the duplex unit in until it is connected to the printer.
If the duplex unit is not attached, this step is not necessary.
❒ After finishing installation, you can check the 802.11b interface unit is prop-
erly installed: Print the configuration page from the “List/Test Print” menu.
If it is installed properly, you will see “IEEE 802.11b” for “Controller Option”.