Filter
Top Products
CRYSTALVIEW PLUS INSTALLATION AND OPERATIONS MANUAL
13
Remote unit to KVM station cabling
(Refer to Figure 2 and Figure 6)
On the remote unit, the KVM station’s keyboard, monitor, and
mouse cables are connected directly to the CrystalView Plus
keyboard, monitor, and mouse connectors.
Serial/audio models
(Refer to page 10 for a description of serial and audio cabling)
Serial port
The serial port on all models is a DB9F on the local unit and DB9M
on the remote unit. The serial port on the remote unit is the same
as the DB9M serial connector on your computer. Serial devices
such as Touchscreens can connect directly to the serial port on the
remote unit
.
Audio ports
A set of powered computer speakers can connect directly to the
CrystalView Plus remote unit’s line level audio out connector. A
powered or non-powered microphone can connect to the Line level
audio in (MIC) connector.
If you are using a non-powered microphone on the Remote Unit,
install the “MIC” jumper, if needed, to provide additional
amplification.
(See page 10 for alternative ways to connect and install a powered
or non-powered microphone)
Local unit to Remote unit cabling
Connect up to 1,000 feet of CAT-x cable from the Local Units RJ45
front panel connector to the Remote Units RJ45 front panel
connector. (See Figure 6)
DO NOT
INSTALL THE “MIC” JUMPER IF USING A
POWERED MICROPHONE.