Filter
Top Products
CRYSTALVIEW PLUS INSTALLATION AND OPERATIONS MANUAL
19
Keyboard command descriptions
Command mode – [L-Ctrl] + [L-Shift] + [F10]
Entering the command mode sends the remote units keyboard
instructions to the CrystalView Plus instead of the connected
computer. In the command mode, the yellow LED on the remote
units RJ45 connector for channel 1 will light indicating that the unit is
in the command mode. The keyboard status LEDs (Num lock, Caps
Lock, and Scroll Lock) will flash indicating which channel is
selected. The Command mode automatically times out after 30
seconds of inactivity, saves all settings, and returns the keyboard to
normal functions.
Number of keyboard
status LED flashes
Video channel selected
1 Channel 1 (Default, all models)
2 Channel 2 (Dual & Quad models)
3 Channel 3 (Quad models)
4 Channel 4 (Quad models)
Slow flashes Channel 0 (All channels)
Table 2. Channel select
Exit Command mode and save – [Esc]
Pressing the Esc key while in the command mode will save all
configuration changes made and exit the command mode.
Exit Command mode without saving – [L-Shift] + [ESC]
Pressing the left shift key and the Esc key while in the command
mode will exit the command mode without saving any configuration
changes.
Select Channel 1 – [1]
Pressing 1 while in the command mode selects channel one and all
configuration adjustments apply to channel 1 only. Keyboard status
LEDs flash once.
Select Channel 2-4 – [2, 3, or 4] (Dual and quad models only)
Pressing 2, 3, or 4 while in the command mode selects that channel
and all configuration adjustments apply to the selected channel
only. Keyboard status LEDs flash twice for channel 2, three times
for channel three, and four times for channel four.
Select Channel 0 – [0] (Dual and quad models only)
Pressing 0 (zero) while in the command mode selects all channels
and all configuration adjustments are applied to all channels.
This is especially helpful if all cable lengths and types used for all
channels are the same.