Filter
Top Products
OPERATING INSTRUCTIONS
CRYSTALVIEW PLUS INSTALLATION AND OPERATIONS MANUAL
27
Operating instructions- All units
Once the Remote and Local Units are connected and configured,
the Remote KVM station’s keyboard, video monitor and mouse will
function as if it were directly connected to the CPU. All applications,
upgrades and PC configurations can be performed normally.
Each Rj45 connector on the remote unit has two LEDs. The left
LED is yellow, the right one is green. The green LED on all
channels will flash if a video signal is being received from the local
unit. If no video signal is being received, the green LED will remain
“ON”. The yellow LED on channel one only will flash indicating that
the keyboard and mouse are active. The video from all sources will
always display on their respective monitor unless the unit is in the
private mode (Dual and Quad models only).
Operating instructions – Dual unit
KVM Switching
The CrystalView Plus “Dual” version allows for an additional KVM
station to be connected to the Local Unit. The CPU can be
operated from either the Remote or Local KVM station but not
simultaneously. The Local Unit is active during boot-up. To activate
the Remote KVM station, simply press any key on the Remote KVM
stations keyboard or move the mouse. To activate the Local KVM
station, press any key on the Local KVM station’s keyboard or move
its mouse. Both the local and remote monitors will display the
current computer activity unless a unit is in the private mode.
A lockout feature disables activity from a KVM station until the “In
Use” KVM stations keyboard or mouse is inactive for more than 2
seconds. After 2 seconds of inactivity, pressing any key on the “Not
in Use” KVMs keyboard or moving the mouse will activate that KVM
station and lockout the other KVM station.
Private mode (Dual access models only)
The private mode feature will disable the keyboard and mouse and
blank the video monitor on the Remote or Local Unit. To enter the
private mode, execute the command shown in Table 3.
Unit Command
Remote [L-Ctrl] + [L-Shift] + [F10] / [Scroll Lock]
Local [“HOT-KEY”] + [Scroll Lock]
(Default “HOT-KEY” = Right Ctrl key)
Table 3. Private mode commands