Filter
Top Products
QUADRAVISTA INSTALLATION AND OPERATIONS MANUAL 21
System / Disable Channel
Using this feature, the connected computers should be connected to the channel ports in
ascending order. Connecting computers to channel 1, 2, and 4 and selecting the number of
channels to be 3, channel 4 can not be displayed.
Figure 13. System / Disable Channel
System / Control
Figure 14. System / Control
The DCP (Device Control Protocol) offers three modes, off, control and synchronize. Set the
DCP mode to “Control” if a single QuadraVista will be controlled from an external computer. Set
the mode to “Synchronize” if you system features several linked QuadraVista’s. When in this
mode the QuadraVista status is transmitted to the external computer. For local unit operation, set
the mode to off. See the Serial Operations section for detailed information on the DCP mode.
Use the Disable Channel function to
select the number of channels to
display. If computers are connected
to channel 1, 2, and 3, then select 3.
The system / control feature allows
setting up of the QuadraVista from a
computer or external device connected
to the serial port.
Selecting control allows external
control of the OSD.
Selecting synchronize will keep
cascaded QuadraVista units in the
same video mode.
See the Serial Operations Section.