Filter
Top Products
Connections
3-1
3
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector
to the wall outlet. Plug the female power connector into
the male connector at the front side of the projector.
Power Check
Power voltage indication is on the sticker on the rear side of the
projector. The power voltage is indicated by the serial number sticker.
Warning !
Check if the indicated power voltage corresponds to that of the wall
outlet.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The main power to the projector is switched ON and OFF using the
power (mains) switch ON/OFF.
Pressed: ON
Not pressed: OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'standby mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch must be
set during installation by a qualified technician. If you want to change
this startup mode, call a qualified technician.
Standby indication lamp:
no light: projector switched off
green color: projector in Operational mode
red color: projector is in Standby mode
When starting up the projector with the power switch or via the stand-
by key, the projector can start up in two ways if the "CRT Run in Cycle"
option is switched OFF:
- full white image (projector warm up) or
- immediately image display.
Your choice of starting can be set in the Service Mode.
V NOM
1 MAX
FREQ
120/230 Volt
7/5 Amp
50/60Hz
RS232 IN RS232 OUT IR REMOTE