Filter
Top Products
Service Mode
7-2
Identification
Highlight
'Identification'
with the control disk and press ENTER.
The 'Identification' screen gives information concerning:
- projector address, to change the address of your projector,
contact a qualified service technician.
- software version
- configuration
possible installations:
* front-ceiling
* front-table
* rear-ceiling
* rear-table
- baud rate PC: transfer speed for communication with an IBM PC
(or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is
a difference, contact a qualified service technician to make the
appropriate changes.
- Text: indicates in operational mode if the bar scale and number
indicator will be displayed and if warnings and failures will be
displayed.
ON: displayed
OFF: not displayed
The status can be changed by pressing the 'TEXT' key once on the
RCU.
- Serial no.: indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
Copy a Block
The Copy A Block function copies the settings of a selected block into
the active block. Highlight
Copy A Block
with the control disk and press
ENTER. ENTER will select the highlighted item.
To copy the settings of a closed block to the block you are working on
(active block), use the control disk to select a block. All existing
settings will be overwritten with the new settings.
Press ENTER to copy the selected block. A confirmation screen will
be displayed.
If you are certain you wish to copy the contents of the selected block
into the active block, press ENTER. EXIT cancels the copy procedure
and returns without copying the block.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baud Rate PC : 9600
Text : ON
Serial No. : 103589552
DTV-1101
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
Select with or
<ENTER> to copy
<EXIT> to return.
COPY MODE
Nr. Src Fh Fv inp conf
1 1 15.650 video FC
2 3 31.260 RGB3S RT
3 - 15.650 intern FC
4 2 31.550 RGB3S FC
5 - 33.760 intern FC
6
7
8
Active block nr. 1
COPY BLOCK
All settings
in current block
will be overwritten!
<ENTER> to confirm
<EXIT> to cancel
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...