Filter
Top Products
Random Access Adjustment Mode
6-3
Selecting Setup Pattern
If an external source is connected to the projector, this menu will be
displayed. Push the control disk up or down to highlight the desired
setup pattern and then press ENTER.
Genlocked pattern: internally generated crosshatch pattern, based
on the scan rate of the external source.
Internal # pattern: internally generated crosshatch pattern and locked
on internal generated sync signals (no external source necessary).
ENTER continues to Random Access Adjustment Mode or Internal #
Pattern Selection.
Note: The menus in this manual are created to demonstrate when an
external source is connected to one of the inputs and when the 'Genlocked
Pattern' is selected.
Internal Crosshatch Pattern
The Internal # Pattern Menu will be displayed if the Internal Crosshatch
Pattern has been selected or if no source is connected to the projector.
The table below lists the 8 fixed factory preset frequencies available.
Another 8 blocks are custom programmable.
Push the control disk up or down to highlight the desired crosshatch
frequency. Push the control disk to the left and to the right to scroll to
another page. Press ENTER if the desired block is selected.
kHz/Hz
15.6/50 PAL/SECAM
15.7/60 NTSC
31.2/50 EDTV
31.5/60 IDTV
31.2/50 HDTV EUREKA
31.5/60 HDTV ATV
33.7/60 HDTV HIVISION
15.8/60 EGA 1
61.0/76 VGA 1,2
35.5/87 VGA 4
48.5/60 SUPER VGA 1
44.2/70 SUPER VGA 2
61.0/76 SUPER VGA 3
72.1/67 SUPER VGA 4
Choose a setup pattern
from below :
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 01
Select with or
then <ENTER>
<EXIT> to return
INTERNAL # PATTERN
kHz / Hz
15.6/50 PAL/SECAM
15.7/60 NTSC
31.2/50 EDTV
31.5/60 IDTV
31.2/50 HDTV EUREKA
31.5/60 HDTV ATV
Select with or
scroll with or
<ENTER> to accept
<EXIT> to return
EXIT returns to Path Selection Menu
ADJUST returns to Operational Mode
If no external source is connected to the projector, the Internal
Crosshatch Pattern Menu will be displayed.
ENTER continues to the Random Access Adjustment Mode
EXIT returns to the Setup Pattern Selection Menu