Filter
Top Products
Controlling
4-2
When using the wireless remote control, make sure you are within the
effective operating distance (30m, 100ft in a straight line). The remote
control unit will not function properly if strong light strikes the sensor
window or if there are obstacles between the remote control unit and
the projector's IR sensor.
IR Receiver Locations on the Projector:
7
65
43
21
0
7
65
43
2
365
The Runco DTV-1101 can be controlled with
a. the RCU
b. the built-in RCU (local keypad)
The procedure and results of controlling the projector with either of
these RCU options is essentially the same.
How to Use Your RCU
a) Point the front of the RCU towards the reflective screen surface.
b) Point the front of the RCU towards one of the IR sensors in the
projector.
Projector Address
a. Software set up of the projector address
See 'Change Projector Address' in Chapter 2, 'Service Mode'.
Every projector requires an individual address between 0 and 255,
which is set in the Service mode. Only projectors with addresses
between 0 and 9 can be controlled with the RCU.
b. How to control the projector
The projector's address may be set to any value between 0 and 255.
When the address is set, the projector can be controlled with:
- the RCU for addresses between 1 and 9.
- computer, e.g. IBM PC (or compatible), Apple MAC, etc. for
addresses between 0 and 255.
Note: Address '0' is a universal address. A projector will respond to
an RCU set to an address of '0' regardless of what address is set in
the projector itself.
c. Using Your RCU
Before using your RCU, it is necessary to enter the projector address
into the RCU (only when that address is between 1 and 9). The
projector with the corresponding address will listen to that specific
RCU.
When address '0' (zero address) is programmed into the RCU, every
projector - without exception - will listen to the commands given by this
RCU.