Filter
Top Products
Messages, warnings and failures
8-1
MESSAGES, WARNINGS AND FAILURES
When selecting a new source, in-
formation about this source will be
displayed on the screen. Source
number, horizontal, and vertical
frequencies of the displayed
source.
SOURCE 05
Announcement of the selected
source.
INPUT 05
Fh= 31.5 kHz
Fv= 60 Hz
enter
password
x x x x
Message to enter your password.
Password contains 4 digits.
text on
text off
These messages will be displayed
on the screen when pushing the TEXT
key.
Text ON : the
'Bar Scale Indication'
will be enabled during the change of
an analog control in the
'Operational
Mode'
+ all warnings and failures
will be displayed.
Text OFF : the
'Bar Scale Indication'
will be disabled during the change of
an analog control in the
'Operational
Mode'
+ all warnings and failures
will not be displayed.
PROJECTOR
ADDRESS :
003
Indication of the projector address
when activating the
'ADDRESS'
button on the RCU with a pencil or
other small object.
WARNING :
source not
available
The input is a valid input but the
source is not connected to the input
terminals or the input source is
switched off.
WARNING :
invalid
key entry
When a wrong key is pressed on the
RCU.
WARNING :
end of ad-
just range
End of adjustment range.
WARNING :
input no
longer
available
Message will be displayed when the
input source is no longer available.
The following message then appears:
'check input signal or select new
source'
.
WARNING :
invalid
frequency
input
The entered frequency or applied
frequency of the source is out of the
projector's range.
table is
deleted
Message to inform that selected ta-
ble is deleted. This message will be
followed by
'confirm message'
,
which the user has to answer.
FAILURE
12C error
addr.: 7FH
Hardware failure. Call a qualified
service technician for repair.
FAILURE
short
circuit on
I2C bus
Hardware failure. Call a qualified
service technician for repair.
WARNING :
invalid
code entry
Message when the entered pass-
word is wrong.
FAN FAILED
Projector
will
switch off
Message when one of the fans is
not working anymore. Projector
switches to stand-by.
8