Filter
Top Products
66
New setting appears on [Basic] menu. Type t and press [ENTER : ↵] if you
would like to return to the top menu [ROOT]. Otherwise, you will remain in
[Basic] menu.
③ Select the following order to change Wireless Channel.
Select slot (A or B) which is you want to set Channel after the phrase “Select
slot {A, B}:”, and press [ENTER : ↵]. We recommend you use different
Channel for each slots refer Notice blow.
Enter the proper channel number after the phrase “Enter new Channel {1-
14}:”. Then, press [ENTER : ↵]. Channel index should be between 1 and
14(differs from country to country).
Notice : If you are operating two or more Access Points in the adjoining cells,
keep the appropriate channel distance to avoid the interference. We recommend
you to keep the distance of at least 4 channels in the adjoining cells.
④ Only if AP is used for DHCP Client, you set DHCP Client with “Enabled”. In
this case, there is no need to set ⑤, ⑥, ⑦ below. The default setting is
“Disabled”.
CMD(t,p,h): 2 ↵
Select slot {A, B}: a ↵
Enter new Channel {1-14}: 5 ↵
CMD(t,p,h): 3 ↵
Enter new DHCP Client {enable, disable}: disable ↵
Select Slot
Enter Channel
Enter DHCP Clien
t
Setting Selection